NOTE: Before disconnecting the camera, verify the connector is properly seated and latched.
PINPOINT TEST A : THE REAR VIDEO IS INOPERATIVE
A1 CHECK AND CLEAN THE REAR VIDEO CAMERA LENS
Clean and make sure the rear video camera lens is clear of any debris. Ignition ON. Test the video camera system and check the video camera image.
Is the video camera concern still present?
Yes | GO to A2 |
|---|---|
No | The system is operating correctly at this time. The concern was caused by a dirty video camera lens. |
A2 CHECK FOR CORRECT GEAR INPUT
Apply the parking brake. While monitoring the reversing lamps, move the selector lever (automatic transmission) or gearshift lever (manual Transmission) through the entire range.
Do the reversing lamps illuminate only in reverse?
Yes | GO to A3 |
|---|---|
No | REFER to: Reversing Lamps (417-01 Exterior Lighting, Diagnosis and Testing). |
A3 PERFORM A NETWORK TEST
Using a diagnostic scan tool, perform a network test.
Do all modules pass the network test?
Yes | GO to A4 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . |
A4 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
Using the diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) retrieved?
Yes | For BCM Diagnostic Trouble Codes (DTCs) B115E:01, B115E:02 or B115E:08, GO to A9 For all other Diagnostic Trouble Codes (DTCs), REFER to the DTC chart in this section. |
|---|---|
No | For vehicles equipped with an 8 in (203 mm) touchscreen display, GO to A5 For vehicles equipped with a 4.2 in (107 mm) display, GO to A7 |
A5 PERFORM THE APIM (SYNC MODULE) RESET
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.