Module Network Input Messages - DACMC (2.3L and 5.2L Only)

Ignition key type

BCM

Used to determine if a MyKey® is enabled and in use.

Ignition status

BCM

Used to indicate the ignition state (OFF, ACCESSORY, RUN, and START) required for APIM operating modes and fault reporting.

MyKey® volume limit status

IPC

Used to limit the maximum audio system volume when a MyKey® restricted key is in use.

Navigation rolling wheel count and direction

ABS module

Used to provide more accurate vehicle position tracking when the GPS signal is temporarily unavailable.

Steering wheel switch status

SCCM

Used to indicate the button press status of the steering wheel switches.

Vehicle configuration data

BCM

Used to verify vehicle configuration data such as the VIN and system module configuration.

Vehicle speed

PCM

Used for navigation functionality.

Accelerator pedal position

PCM

Used to determine the throttle position status for the ANC system operation.

Driver's door ajar status

BCM

Used to enable the ANC system if the driver’s door (and all other doors and luggage compartment lid) is closed, or to disable the ANC system if the driver's door is ajar.

Engine RPM data

PCM

Used to determine the engine rotation speed for the ANC system operation.

Engine status

PCM

Used to enable the ANC system if the engine is ON, or to disable the ANC system if the engine is OFF or Auto-Stopped.

Engine torque

PCM

Used for ANC system operation by indicating the amount of engine torque being produced (in Nm).

Ignition status

GWM

Used to indicate the ignition state (OFF, ACCESSORY, CRANK, RUN, and START) required for DACMC operating modes and fault reporting.

Luggage compartment lid ajar status

BCM

Used to enable the ANC system if the luggage compartment lid (and all other doors) is closed, or to disable the ANC system if the luggage compartment lid is ajar.

Passenger door ajar status

BCM

Used to enable the ANC system if the front passenger door (and all other doors and luggage compartment lid) is closed, or to disable the ANC system if the front passenger door is ajar.

Power up chime modules

IPC

Used to initiate the audio system as the chime source.

ACM CD data

ACM

Used to display CD data on the FCDIM.