DTC Description Action Testing). • If no Diagnostic Trouble Codes (DTCs) are present in the RCM, DIAGNOSE the observable symptom. U2100:00 Initial Configuration Not This DTC sets due to an incorrect or incomplete APIM Complete: No Sub Type programming/provisioning. Using a diagnostic scan tool, Information PERFORM the APIM programming procedure. REFER to: SYNC Module [APIM] Programming (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, General Procedures). U2101:00 Control Module Configuration This DTC sets due to an incorrect or incomplete APIM Incompatible: No Sub Type programming/provisioning. Using a diagnostic scan tool, Information PERFORM the APIM programming procedure. REFER to: SYNC Module [APIM] Programming (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, General Procedures). U3000:04 Control Module: System Internal CLEAR the Diagnostic Trouble Codes (DTCs). Failure WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:04 is retrieved again, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). U3000:41 Control Module: General CLEAR the Diagnostic Trouble Codes (DTCs). Checksum Failure WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). U3000:42 Control Module: General Memory CLEAR the Diagnostic Trouble Codes (DTCs). Failure WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). U3000:88 Control Module: Bus Off NOTE: The module was unable to communicate on the network at a point in time. The fault is not currently present since the module had to communicate with the diagnostic scan tool to report this DTC. To avoid repeat network concerns: INSPECT for damaged or corroded wiring at the APIM. Refer to Wiring Diagrams Cell 14 for schematic and connector information. CLEAR the DTC. WAIT at least 10 seconds. REPEAT the network test with the diagnostic scan tool. U3003:16 Battery Voltage: Circuit Voltage GO to Pinpoint Test AQ Below Threshold U3003:17 Battery Voltage: Circuit Voltage GO to Pinpoint Test AR Above Threshold
Original table alignment retained · Scroll horizontally if needed
Source reference 4105
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.