Is the resistance greater than 10,000 ohms?
Yes | GO to Y13 | |
|---|---|---|
No | INSTALL a new clockspring. REFER to: Clockspring (501-20B Supplemental Restraint System, Removal and Installation). | |
Y13 CHECK FOR CORRECT SCCM (STEERING COLUMN CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all the SCCM connectors. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the SCCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). | |
|---|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. | |
The Audio System Does Not Operate Correctly From The FCIM
Normal Operation and Fault Conditions
REFER to: Information and Entertainment System - System Operation and Component Description (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Description and Operation). See Audio Extended Play, FCDIM, and FCIM.
Possible Sources
Wiring, terminals, or connectors FCIM FCDIM
PINPOINT TEST Z : THE AUDIO SYSTEM DOES NOT OPERATE CORRECTLY FROM THE FCIM
(FRONT CONTROLS INTERFACE MODULE)
Z1 VERIFY THAT THE ACM (AUDIO FRONT CONTROL MODULE) AND FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) PASS THE NETWORK TEST
Using a diagnostic scan tool, perform the network test.
Did the ACM and FCDIM pass the network test?
Original table alignment retained · Scroll horizontally if needed
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.