Reconnect the RCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new RCM. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
U0155:00
Normal Operation and Fault Conditions
REFER to: Information and Entertainment System - System Operation and Component Description (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Description and Operation). See Network Message Chart.
DTC Fault Trigger Conditions
Description | Fault Trigger Conditions |
|---|---|
U0155:00 Lost Communication With IPC Control Module: No Sub Type Information | Set by the ACM, APIM, FCDIM, FCIM, and GPSM when network messages are missing from the IPC for more than 5 seconds with the ignition in RUN. |
DTC
Possible Source
IPC
PINPOINT TEST AI : U0155:00
AI1 VERIFY THE CUSTOMER'S CONCERN
Ignition ON. Verify there is an observable symptom present.
Is an observable symptom present?
Yes | GO to AI2 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.