PINPOINT TEST AJ : U0159:00
AJ1 VERIFY THE CUSTOMER'S CONCERN
Is an observable symptom present?
Yes | GO to AJ2 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
AJ2 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0159:00
Ignition ON. Using a diagnostic scan tool, clear all Continuous Memory Diagnostic Trouble Codes (CMDTCs). Ignition OFF. Ignition ON. Wait at least 10 seconds. Using a diagnostic scan tool, retrieve all Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U0159:00 set in the FCDIM?
Yes | GO to AJ3 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
AJ3 CHECK THE BCM (BODY CONTROL MODULE) FOR BATTERY VOLTAGE OUT-OF-RANGE DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the BCM self-test.
Are any low or high voltage Diagnostic Trouble Codes (DTCs) recorded in the BCM?
Yes | • For DTC U3006:16, REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). See U3006:16. • For DTC U3006:17, REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). See U3006:17. |
|---|---|
No | GO to AJ4 |
AJ4 CHECK THE APIM (SYNC MODULE) FOR BATTERY VOLTAGE OUT-OF-RANGE DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the FCDIM self-test.
Are low or high voltage Diagnostic Trouble Codes (DTCs) recorded in the FCDIM?
Yes | • For DTC U3003:16, GO to Pinpoint Test AQ • For DTC U3003:17, GO to Pinpoint Test AR |
|---|---|
No | GO to AJ5 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.