U0184:00
Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
Description | Fault Trigger Conditions |
|---|---|
U0184:00 Lost Communication With Radio: No Sub Type Information | Set by the APIM and FCDIM when network messages are missing from the ACM for more than 5 seconds with the ignition in RUN. |
DTC
Possible Source
ACM
PINPOINT TEST AL : U0184:00
AL1 VERIFY THE CUSTOMER'S CONCERN
Verify there is an observable symptom present.
Is an observable symptom present?
Yes | GO to AL2 |
|---|---|
No | The system is operating normally at this time. This DTC may have been set due to high network traffic or an intermittent fault condition. |
AL2 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0184:00
Ignition ON. Using a diagnostic scan tool, clear all Continuous Memory Diagnostic Trouble Codes (CMDTCs). Ignition OFF. Ignition ON. Wait at least 10 seconds. Using a diagnostic scan tool, retrieve all Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U0184:00 set in the APIM?
Yes | GO to AL3 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
AL3 CHECK FOR BATTERY VOLTAGE OUT-OF-RANGE DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the self-test for the following modules:
ACM APIM
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.