DTC Description Action Information U0253:00 Lost Communication With GO to Pinpoint Test AU Accessory Protocol Interface Module: No Sub Type Information U0256:00 Lost Communication With GO to Pinpoint Test AV Front Controls Interface Module “A”: No Sub Type Information U201A:51 Control Module Main This DTC sets due to an incorrect or incomplete ACM configuration. Calibration Data: Not Using a diagnostic scan tool, PERFORM the ACM programming Programmed procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U2100:00 Initial Configuration Not This DTC sets due to an incorrect or incomplete ACM configuration. Complete: No Sub Type Using a diagnostic scan tool, PERFORM the ACM programming Information procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U2101:00 Control Module This DTC sets due to an incorrect or incomplete ACM configuration. Configuration Incompatible: Using a diagnostic scan tool, PERFORM the ACM programming No Sub Type Information procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U3000:41 Control Module: General CLEAR the DTC. Checksum Failure WAIT at least 10 seconds. REPEAT the ACM self-test. If DTC U3000:41 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B) . U3000:42 Control Module: General CLEAR all Continuous Memory Diagnostic Trouble Codes Memory Failure (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B) . U3000:96 Control Module: CLEAR the DTC. Component Internal Failure WAIT at least 10 seconds. REPEAT the ACM self-test. If DTC U3000:96 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B) . U3003:16 Battery Voltage: Circuit GO to Pinpoint Test AW Voltage Below Threshold U3003:17 Battery Voltage: Circuit GO to Pinpoint Test AX Voltage Above Threshold
Original table alignment retained · Scroll horizontally if needed
DTC Chart: APIM
Description | Action | |||
|---|---|---|---|---|
DTC | ||||
B108E:01 | Display: General Electrical Failure | GO to Pinpoint Test AE | ||
Source reference 4312
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.