Description | Action | |||
|---|---|---|---|---|
DTC | ||||
U0237:00 | Lost Communication With Digital Audio Control Module "C": No Sub Type Information | GO to Pinpoint Test AS | ||
U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AU | ||
U0423:00 | Invalid Data Received from Instrument Panel Cluster Control Module: No Sub Type Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: Instrumentation, Message Center and Warning Chimes (413-01) . • If no Diagnostic Trouble Codes (DTCs) are present in the IPC, DIAGNOSE the observable symptom. | ||
U201A:51 Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete audio DSP module configuration. Using a diagnostic scan tool, PERFORM the audio DSP module programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. | |||
U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete audio DSP module configuration. Using a diagnostic scan tool, PERFORM the audio DSP module programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. | ||
U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete audio DSP module configuration. Using a diagnostic scan tool, PERFORM the audio DSP module programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. | ||
U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the audio DSP module self-test. If DTC U3000:41 is retrieved again, INSTALL a new audio DSP module. REFER to: Audio Digital Signal Processing (DSP) Module (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). | ||
U3000:42 | Control Module: General Memory Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, INSTALL a new audio DSP module. REFER to: Audio Digital Signal Processing (DSP) Module (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). | ||
U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AW | ||
U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AX | ||
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.