DTC Chart: DACMC - 2.3L And 5.2L Only
DTC Description Action B116A:01 Handset Microphone: General GO to Pinpoint Test AH Electrical Failure B117A:01 Backup Microphone: General GO to Pinpoint Test AI Electrical Failure B13F5:01 Microphone 3: General GO to Pinpoint Test AJ Electrical Failure U0100:00 Lost Communication With GO to Pinpoint Test AK ECM/ PCM "A": No Sub Type Information U0140:00 Lost Communication With Body GO to Pinpoint Test AM Control Module: No Sub Type Information U0142:00 Lost Communication With Body GO to Pinpoint Test AN Control Module "B": No Sub Type Information U2024:00 Control Module Cal-Config This DTC sets due to an incorrect or incomplete DACMC Data: No Sub Type Information configuration. Using a diagnostic scan tool, PERFORM the DACMC programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U2100:00 Initial Configuration Not This DTC sets due to an incorrect or incomplete DACMC Complete: No Sub Type configuration. Using a diagnostic scan tool, PERFORM the DACMC Information programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U2101:00 Control Module Configuration This DTC sets due to an incorrect or incomplete DACMC Incompatible: No Sub Type configuration. Using a diagnostic scan tool, PERFORM the DACMC Information programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration (418-01) . See As-Built Data. U3000:41 Control Module: General CLEAR the Diagnostic Trouble Codes (DTCs). Checksum Failure WAIT at least 10 seconds. REPEAT the DACMC self-test. If DTC U3000:41 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B) . U3000:42 Control Module: General CLEAR all Continuous Memory Diagnostic Trouble Codes Memory Failure (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B) . U3000:92 Control Module: Performance GO to Pinpoint Test F or Incorrect Operation U3000:94 Control Module: Unexpected If an observable symptom is not present, DISREGARD this Operation DTC. If an observable symptom is present, GO to Pinpoint Test F
Original table alignment retained · Scroll horizontally if needed
Source reference 4320
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.