No | INSTALL a new AM/ FM/satellite radio/ GPS antenna. REFER to: Satellite Radio Antenna (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). |
|---|
AG21 CHECK FOR CORRECT ACM (AUDIO FRONT CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all the ACM connectors. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the ACM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
AG22 CHECK FOR CORRECT APIM (SYNC MODULE) OPERATION
Ignition OFF. Disconnect and inspect the APIM connector. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the APIM connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
B116A:01
Refer to Wiring Diagrams Cell 131 for schematic and connector information.
Normal Operation and Fault Conditions
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.