MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

P061C - Internal Control Module Engine RPM Performance

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,872 / 6,619HTML edition
← Chapter contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

Powertrain DTC Charts and Descriptions 4-85

Diagnostic Trouble Code (DTC) Charts and Descriptions

P061C - Internal Control Module Engine RPM Performance (Continued)

• CMP circuit intermittent

• Damaged crankshaft position (CKP) sensor

• Damaged camshaft position (CMP) sensor

• Damaged PCM

Diagnostic Aids: Verify correct operation of the CKP and CMP sensors and related circuits.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test QE.

P061D - Internal Control Module Engine Air Mass Performance

Description: This DTC sets when an error occurs in the PCM.

Possible Causes: • Software incompatibility issue

• Damaged PCM

Diagnostic Aids: Verify the PCM is at the latest calibration level.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test QE.

P061E - Internal Control Module Brake Signal Performance

Description: This DTC sets when an incorrect brake pedal position (BPP) sensor signal is received by the PCM. This DTC

also sets when an internal PCM communication error occurs in the PCM.

Possible Causes: • Incorrectly adjusted BPP sensor

• Damaged BPP sensor

• Damaged PCM

Diagnostic Aids: Check for an incorrectly adjusted BPP sensor. Refer to Workshop Manual Section 417-01, Exterior Lighting.

Check for other DTCs and diagnose those first. Check for aftermarket performance products before installing a new PCM. Clear the DTCs, repeat the self-test. If the DTC is retrieved again, install a new PCM. Refer to Section 2, Flash Electrically Erasable Programmable Read Only Memory (EEPROM), Programming the VID Block for a Replacement PCM.

Application Key On Engine Off Key On Engine Running Continuous Memory

All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.

P061F - Internal Control Module Throttle Actuator Controller Performance

Description: This DTC sets when an error occurs in the PCM.

Possible Causes:

Diagnostic Aids: Verify correct operation of the electronic throttle control (ETC) components and related circuits.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test QE.

P061x -

Description:

Possible Causes:

Diagnostic Aids: Refer to the Workshop Manual Section 303-14, Electronic Engine Controls.

Application Key On Engine Off Key On Engine Running Continuous Memory

All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.

2016 Powertrain Control/Emissions Diagnosis, Gasoline Engines, 3/2015

Source reference 4872

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.