MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

AB: Cold Start System AB: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,950 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

Is the resistance less than 5 ohms?

Yes

No

GO to AB17 .

REPAIR the open circuit. Clear the PCM DTCs. REPEAT the self-test.

AB17 CHECK THE CIRCUITS

• PCM connector disconnected.

• Measure the resistance between:

( + ) Cold Start Relay Connector, Harness Side

( - ) PCM Connector, Harness Side

CSRC

CSRC

CSM

CSM

• Measure the resistance between:

( + ) Cold Start Valve Connector, Harness Side

( - ) PCM Connector, Harness Side

CSV

CSV

Are the resistances less than 5 ohms?

Yes

No

GO to AB18 .

REPAIR the open circuit. Clear the PCM DTCs. REPEAT the self-test.

AB18 CHECK FOR A SHORT TO GROUND

• Measure the resistance between:

( + ) Cold Start Relay Connector, Harness Side

( - )

CSRC

Ground

• Measure the resistance between:

( + ) Cold Start Valve Connector, Harness Side

( - )

CSV

Ground

Are the resistances greater than 10K ohms?

Yes

No

GO to AB19 .

REPAIR the short circuit. Clear the PCM DTCs. REPEAT the self-test.

Source reference 4950

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.