MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

AB: Cold Start System AB: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,952 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

CSV

Negative terminal

• Connect a 5 amp fused jumper wire between the following:

Point A Cold Start Valve Connector, Component Side

Point B Vehicle Battery

VPWR

Positive terminal

• Remove the jumper wires.

Does the pressure in the cold start fuel line decrease after the jumper wires are connected and does the pressure increase after the jumper wires are removed.

Yes

No

GO to AB22 .

INSTALL a new Cold Start valve. Clear the PCM DTCs. REPEAT the self-test.

AB22 CHECK THE COLD START FUEL PUMP

Note: Disconnect the jumper wires at the first sign of fuel entering the approved gasoline fuel container.

• Cold Start Fuel Pump connector disconnected.

• Securely connect an approved gasoline fuel hose (obtained locally) to the cold start fuel pump outlet port that is long enough to route to an approved gasoline fuel container.

• Securely route the approved gasoline fuel hose to an approved gasoline fuel container away from any heat sources or any other ignition sources.

• Connect a 5 amp fused jumper wire between the following:

Point A Cold Start Fuel Pump Connector, Component Side

Point B Vehicle Battery

CSM - Pin 2

Positive terminal

• Connect a 5 amp fused jumper wire between the following:

Point A Cold Start Fuel Pump Connector, Component Side

Point B Vehicle Battery

GND - Pin 1

Negative terminal

• Verify fuel is flowing into the approved gasoline fuel container.

• Remove the jumper wires.

Does fuel flow from the cold start fuel pump when the jumper wires are connected?

Yes

No

For symptoms without DTCs, RETURN to Section 3 , Symptom Charts for further direction.

For all others, GO to AB23 .

INSTALL a new Cold Start Fuel Pump. Clear the PCM DTCs. REPEAT the self-test.

Source reference 4952

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.