MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

EM: Emission Compliance EM: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,106 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

EM22 EVAP SYSTEM CONCERN: PRELIMINARY CHECKS

• Analyze the I/M test report to determine when the concern is present. Attempt to verify the concern.

• Check the following:

◾ fuel filler cap (if equipped) ◾ capless fuel tank filler pipe (if equipped) ◾ EVAP system lines and hoses for correct connections, damage or blockage ◾ fuel vapor storage canister damage

Is a concern present?

Yes

No

REPAIR as necessary.

After any repair,

GO to EM25 .

GO to EM23 .

EM23 CARRY OUT THE PCM QUICK TEST

• Carry out the PCM Quick Test to access any PCM DTCs. For the procedure information, refer to Section 3 , Symptom Charts.

Is a concern present?

Yes

No

FOLLOW the Section 3 Quick Test direction.

After any repair,

GO to EM25 .

GO to EM24 .

EM24 EVAP SYSTEM CHECK

• Check the EVAP system for leaks. GO to Pinpoint Test HX and follow the pinpoint test direction.

Is a concern present?

Yes

No

REPAIR as necessary.

After any repair,

GO to EM25 .

VERIFY the test step results.

If all the test steps are OK, GO to Pinpoint Test Z .

For additional symptoms, RETURN to Section 3 , Symptoms Charts for further direction.

After any repair,

GO to EM25 .

Source reference 5106

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.