MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

EM: Emission Compliance EM: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,104 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

EM15 CHECK THE BASE ENGINE

• Check for base engine concerns. Refer to the Workshop Manual Section 303-00, Engine System.

Is a concern present?

Yes

No

REPAIR as necessary.

After any repair,

GO to EM26 .

GO to EM27 .

EM16 HIGH HC WITH A NORMAL TO LOW CO LEVEL

• Check the fuel delivery system for concerns. GO to Pinpoint Test HC and follow the pinpoint test direction.

Is a concern present?

Yes

No

FOLLOW the pinpoint test direction.

After any repair,

GO to EM26 .

GO to EM17 .

EM17 CHECK THE SECONDARY IGNITION

• For ignition coil on plug (COP) equipped vehicles, GO to JB3 and follow the pinpoint test direction.

• For ignition coil pack equipped vehicles, GO to JC3 and follow the pinpoint test direction.

Is a concern present?

Yes

No

FOLLOW the pinpoint test direction.

After any repair,

GO to EM26 .

GO to EM18 .

EM18 CHECK FOR VACUUM LEAKS OR OBSTRUCTIONS IN THE PCV SYSTEM (SUCH AS OIL CAP, PCV VALVE, HOSES, CUT GROMMETS, VALVE COVER BOLT TORQUE OR GASKET LEAK)

• GO to HG2 and follow the pinpoint test direction.

Is a concern present?

Yes

No

FOLLOW the pinpoint test direction.

GO to EM19 .

Source reference 5104

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.