Description | Fault Trigger Conditions | |||
|---|---|---|---|---|
DTC | ||||
U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | This DTC sets when the BCM has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. | ||
U3000:49 | Control Module: Internal Electronic Failure | This DTC sets when the BCM has permanently shut down the output driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. CORRECT the cause of the excessive current draw before installing a new BCM. | ||
Possible Sources
Wiring, terminals or connectors Autolamp and rain sensor or sunload sensor BCM
Visual Inspection and Diagnostic Pre-checks
Inspect the headlamp switch for damage. Inspect the light sensor for damage.
PINPOINT TEST B : THE AUTOLAMPS ARE ON CONTINUOUSLY
B1 CHECK FOR BCM (BODY CONTROL MODULE) DIAGNOSTIC TROUBLE CODE (DTCS)
Ignition ON. Using a diagnostic scan tool, perform the BCM self-test.
Are any BCM DTC present?
Yes | For DTC B1A85:11, GO to B3 For DTC B1A85:13, GO to B6 |
|---|---|
No | GO to B2 |
B2 CHECK FOR VOLTAGE TO THE LIGHT SENSOR (NO DTC (DIAGNOSTIC TROUBLE CODE) )
Ignition OFF. Disconnect: Autolamp and Rain Sensor C287 (EMTC). Disconnect: Sunload Sensor C286 (DATC). Ignition ON. Place the headlamp switch in the AUTOLAMPS position. Measure:
Click to display connectors
Vehicles With EMTC
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C287-2 | Ground |
Click to display connectors
Vehicles With DATC
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.