RH Fog Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C162-1 | C162-2 |
Is the voltage greater than 11 volts?
Yes | For halogen fog lamps, INSTALL a new front fog lamp bulb. REFER to: Front Fog Lamp Bulb (417-01 Exterior Lighting, Removal and Installation). For LED fog lamps, INSTALL a new front fog lamp assembly. REFER to: Front Fog Lamp (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | REPAIR the circuit. |
C4 CHECK FOG LAMP VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO GROUND
Place the headlamp switch in the OFF position. Ignition OFF. Disconnect: BCM C2280G. Measure:
Click to display connectors
LH Fog Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C152-1 | Ground |
Click to display connectors
RH Fog Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C162-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to C5 |
|---|---|
No | REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). |
C5 CHECK FOG LAMP VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.