No | REMOVE the fuse jumper wire. GO to B7 |
|---|
B7 CHECK THE LOW BEAM POWER SUPPLY CIRCUITS FOR AN OPEN
Ignition OFF. Place the headlamp switch in the OFF position. Disconnect: LH Headlamp C1021 or RH Headlamp C1041. Connect a fused jumper wire:
Click to display connectors
LH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
LH Headlamp Relay Socket Pin 3 | LH Headlamp Relay Socket Pin 5 |
Click to display connectors
RH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
RH Headlamp Relay Socket Pin 3 | RH Headlamp Relay Socket Pin 5 |
Measure:
Click to display connectors
LH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1021-10 | Ground |
Click to display connectors
RH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1041-10 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to B8 | |
|---|---|---|
No | REPAIR the circuit. | |
B8 CHECK THE HEADLAMP GROUND CIRCUITS FOR AN OPEN
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.