Parking, Rear and License Plate Lamps — 2016 workshop reference 5677

DTC Description Fault Trigger Conditions B149F:15 Right Front A continuous memory and on-demand DTC that sets when the BCM Position/Sidemarker: Circuit detects a short to voltage from the RH front parking lamp output Short To Battery or Open circuit. U1000:00 Solid State Driver Protection This DTC sets when the BCM has temporarily shut down the output Active -Driver Disabled: No driver. The module has temporarily disabled an output because an Sub Type Information excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. U3000:49 Control Module: Internal This DTC sets when the BCM has permanently shut down the output Electronic Failure driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. CORRECT the cause of the excessive current draw before installing a new BCM.

Original table alignment retained · Scroll horizontally if needed

Possible Sources

Wiring, terminals or connectors Low beams concern BCM

PINPOINT TEST B : THE PARKING, REAR OR LICENSE PLATE LAMPS ARE ON CONTINUOUSLY

B1 CHECK LOW BEAM HEADLAMP OPERATION

Ignition ON. Place the headlamp switch in the OFF position. Observe the operation of the LH and RH low beams.

Are the low beams illuminated?

Yes		REFER to: Headlamps (417-01 Exterior Lighting, Diagnosis and Testing).
No		GO to B2

B2 CHECK THE BCM (BODY CONTROL MODULE) PARKING LAMP OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE

Ignition OFF. Disconnect: BCM C2280C (For rear side marker or license plate lamps). Disconnect: BCM C2280E (For rear parking lamps). Disconnect: BCM C2280F (For front parking lamps). Disconnect: BCM C2280G (For front side marker lamps). Ignition ON.

Do the parking lamps continue to illuminate?

Yes		REPAIR the affected circuit.
No		GO to B3

B3 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION

Source reference 5677

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.