No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
|---|
One Turn Signal Lamp Is Inoperative Or Always On - China Only
Refer to Wiring Diagrams Cell 90 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Exterior Lighting - System Operation and Component Description (417-01 Exterior Lighting, Description and Operation).
DTC Fault Trigger Conditions
Description | Fault Trigger Conditions | |||
|---|---|---|---|---|
DTC | ||||
B123A:11 | Left Front Turn Indicator: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the LH front turn lamp voltage supply circuit. | ||
B123A:15 Left Front Turn Indicator: Circuit Short To Battery Or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the LH front turn lamp voltage supply circuit. | |||
B123B:11 | Right Front Turn Indicator: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the RH front turn lamp voltage supply circuit. | ||
B123B:15 Right Front Turn Indicator: Circuit Short To Battery Or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the RH front turn lamp voltage supply circuit. | |||
B1247:11 | Left Rear Turn Indicator: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the LH rear turn lamp voltage supply circuit. | ||
B1247:15 | Left Rear Turn Indicator: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the LH rear turn lamp voltage supply circuit. | ||
B1248:11 | Right Rear Turn Indicator: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the RH rear turn lamp voltage supply circuit. | ||
B1248:15 | Right Rear Turn Indicator: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the RH rear turn lamp voltage supply circuit. | ||
U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | This DTC sets when the BCM has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. | ||
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.