Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C499-7 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to B17 |
|---|---|
No | REPAIR the circuit. |
B17 CHECK THE REAR TURN LAMP OUTAGE CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
LH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C498-7 | C4368A-8 |
Click to display connectors
RH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C499-7 | C4368A-20 |
Is the resistance less than 3 ohms?
Yes | GO to B21 |
|---|---|
No | REPAIR the circuit. |
B18 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all BCM connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.