LH Exterior Mirror Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-3 | Ground |
Click to display connectors
RH Exterior Mirror Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-3 | Ground |
For hood turn signal lamp, measure:
Click to display connectors
LH Hood Turn Signal Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1638-1 | Ground |
Click to display connectors
RH Hood Turn Signal Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1684-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to B14 |
|---|---|
No | With memory seat, REPAIR the circuit. Without memory seat, REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). |
B14 CHECK THE MIRROR TURN LAMP OR HOOD TURN SIGNAL LAMP SUPPLY CIRCUIT FOR AN OPEN
For exterior mirror turn lamp, without memory seat, measure:
Click to display connectors
LH Exterior Mirror Turn Lamp
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.