RH Exterior Mirror Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-3 | Ground |
For hood turn signal lamp, measure:
Click to display connectors
LH Hood Turn Signal Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1638-1 | Ground |
Click to display connectors
RH Hood Turn Signal Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1684-1 | Ground |
Does the voltage alternate from 0 to greater than 11 volts?
Yes | GO to B12 |
|---|---|
No | Without memory seat, GO to B11 With memory seat, GO to B13 |
B11 REPEAT THE ON-DEMAND SELF-TEST AND CHECK FOR VOLTAGE TO THE EXTERIOR MIRROR OR HOOD TURN SIGNAL LAMP
Deactivate the hazard lamp function. Using a diagnostic scan tool, perform the BCM self-test. Clear the Diagnostic Trouble Codes (DTCs) and repeat the self-test (required to enable the lamp output driver if DTC U1000:00 is present). Activate the hazard flasher lamp function.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.