No | REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). |
|---|
B9 CHECK THE FRONT TURN LAMP SUPPLY CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
LH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C156-3 | C2280F-39 |
Click to display connectors
RH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1042-3 | C2280F-38 |
Is the resistance less than 3 ohms?
Yes | GO to B18 |
|---|---|
No | REPAIR the circuit. |
B10 CHECK FOR VOLTAGE TO THE EXTERIOR MIRROR OR HOOD TURN SIGNAL LAMP
Ignition OFF. Deactivate the hazard flasher lamp function. Disconnect: For exterior mirror turn lamp, LH Exterior Mirror C520 or RH Exterior Mirror C626. Disconnect: For hood turn signal lamp, LH Hood Turn Signal Lamp C1638 or RH Hood Turn Signal Lamp C1684. Ignition ON. Activate the hazard flasher lamp function. For exterior mirror turn lamp, measure:
Click to display connectors
LH Exterior Mirror Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-3 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.