RH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1042-3 | Ground |
Does the voltage alternate from 0 to greater than 11 volts?
Yes | GO to B7 |
|---|---|
No | GO to B6 |
B6 REPEAT THE ON-DEMAND SELF-TEST AND CHECK FOR VOLTAGE TO THE FRONT TURN LAMP
Deactivate the hazard lamp function. Using a diagnostic scan tool, perform the BCM self-test. Clear the Diagnostic Trouble Codes (DTCs) and repeat the self-test (required to enable the lamp output driver if DTC U1000:00 is present). Activate the hazard flasher lamp function. Measure:
Click to display connectors
LH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C156-3 | Ground |
Click to display connectors
RH Turn Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1042-3 | Ground |
Does the voltage alternate from 0 to greater than 11 volts?
Yes | INSTALL a new front turn signal bulb. REFER to: Front Turn Signal Lamp Bulb (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | GO to B8 |
B7 CHECK THE FRONT TURN LAMP GROUND CIRCUIT FOR AN OPEN
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.