No | REPAIR the door ajar input circuit in question. |
|---|
D5 CHECK THE DOOR LATCH RETURN CIRCUIT TO THE DOOR MODULE FOR AN OPEN
Disconnect: suspect door module. Connect a fused jumper wire:
Click to display connectors
LH Front Door Ajar Switch
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C501B-12 | Ground |
Click to display connectors
RH Front Door Ajar Switch
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C652B-12 | Ground |
Close the door. Monitor the BCM DOOR_SW_DRVR and DOOR_SW_PSGR Parameter Identifications (PIDs).
Does the PID indicate the door is closed?
Yes | REMOVE the fused jumper wire. For LH door, GO to D7 For RH door, GO to D8 |
|---|---|
No | REMOVE the fused jumper wire. REPAIR the door latch return circuit in question. |
D6 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all BCM connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. CLEAR the Diagnostic Trouble Codes (DTCs). |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.