Does the luggage compartment lamp illuminate?
Yes | REMOVE the fused jumper wire. GO to F7 |
|---|---|
No | REMOVE the fused jumper wire. REPAIR the circuit. |
F7 CHECK THE LUGGAGE COMPARTMENT LID LATCH GROUND CIRCUIT FOR AN OPEN
Connect:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4339-2 | C4339-4 |
Does the luggage compartment lamp illuminate?
Yes | REMOVE the fused jumper wire. INSTALL a new luggage compartment lid latch. REFER to: Luggage Compartment Lid Latch - Coupe (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). REFER to: Luggage Compartment Lid Latch - Convertible (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). |
|---|---|
No | REMOVE the fused jumper wire. REPAIR the circuit. |
The Battery Saver Does Not Deactivate After Time-out
Refer to Wiring Diagrams Cell 89 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Interior Lighting - System Operation and Component Description (417-02 Interior Lighting, Description and Operation).
Possible Sources
Wiring, terminals or connectors BCM
PINPOINT TEST G : THE BATTERY SAVER DOES NOT DEACTIVATE AFTER TIME-OUT
G1 CHECK THE DEMAND LAMP VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect: BCM C2280C. Turn any demand lamp (map or vanity mirror) on.
Does the demand lamp turn on?
Yes | REPAIR the circuit. |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.