Is the voltage greater than 11 volts?
Yes | INSTALL a new overhead console. REFER to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation). |
|---|---|
No | REPAIR the circuit. |
E9 CHECK THE CENTER CONSOLE BIN LAMP VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
Ignition OFF. Disconnect: Center Console Lock Assembly C3463. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3463-2 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to E10 |
|---|---|
No | REPAIR the circuit. |
E10 CHECK THE CENTER CONSOLE BIN LAMP GROUND CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3463-2 | C3463-3 |
Is the voltage greater than 11 volts?
Yes | INSTALL a new center console bin lamp. |
|---|---|
No | REPAIR the circuit. |
E11 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all BCM connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.