DTC | Description | Fault Trigger Conditions |
|---|---|---|
Ground | ||
B1281:15 | Ambient Lighting Zone 1 Output Blue LED: Circuit Short To Battery or Open | An on-demand DTC that sets when the Body Control Module B (BCMB) module detects an open or a short to voltage from the zone 1 blue ambient lighting output circuit. |
B1283:11 | Ambient Lighting Zone 3 Output Blue LED: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the Body Control Module B (BCMB) module detects a short to ground from the zone 3 blue ambient lighting output circuit |
B1283:15 | Ambient Lighting Zone 3 Output Blue LED: Circuit Short To Battery or Open | An on-demand DTC that sets when the Body Control Module B (BCMB) module detects an open or a short to voltage from the zone 3 blue ambient lighting output circuit. |
U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | This DTC sets when the Body Control Module B (BCMB) has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Body Control Module B (BCMB) cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. |
U3000:49 | Control Module: Internal Electronic Failure | This DTC sets when the Body Control Module B (BCMB) has permanently shut down the output driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the Body Control Module B (BCMB) can withstand. CORRECT the cause of the excessive current draw before installing a new Body Control Module B (BCMB). |
Possible Sources
Wiring, terminals or connectors Ambient lighting LED Body Control Module B (BCMB)
PINPOINT TEST I : THE AMBIENT LIGHTING DOES NOT CYCLE THROUGH ALL COLOR
COMBINATIONS
I1 CHECK THE AMBIENT LIGHTING
Ignition ON. Place the headlamp switch in the PARKING LAMPS ON position. Observe the operation of all the ambient lighting Light Emitting Diodes (LEDs).
Are all ambient lighting Light Emitting Diodes (LEDs) effected?
Yes | GO to I3 | |
|---|---|---|
No | GO to I2 | |
I2 CHECK THE AMBIENT LIGHTING COLOR OUTPUT CIRCUITS
Ignition OFF. Disconnect: Body Control Module B (BCMB) C4368A. Disconnect: Body Control Module B (BCMB) C4368B. For front footwell, interior door release handle and cup holder Light Emitting Diodes (LEDs), measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.