Is the resistance less than 3 ohms?
Yes | CONNECT negative battery cable. GO to K5 |
|---|---|
No | REPAIR the circuit. |
K5 CHECK FOR CORRECT FCIM (FRONT CONTROLS INTERFACE MODULE) OPERATION
Ignition OFF. Disconnect and inspect all the FCIM connectors and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the FCIM connectors and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new FCIM. For AM/FM/CD /SYNC, REFER to: Front Controls Interface Module (FCIM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). For touchscreen display, REFER to: Front Controls Interface Module (FCIM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
The Front Control/Display Intertace Module (FCDIM) Does Not Respond To The Diagnostic Scan Tool
Refer to Wiring Diagrams Cell 14 for schematic and connector information.
Refer to Wiring Diagrams Cell 131 for schematic and connector information.
Refer to Wiring Diagrams Cell 132 for schematic and connector information.
Normal Operation and Fault Conditions
The FCDIM communicates on the HS-CAN3, and communicates with the diagnostic scan tool through the HS-CAN2. Diagnostic messages are sent/received through the HS-CAN2 circuits at the DLC, and translated through the GWM to the HS-CAN3.
Possible Sources
Fuse Wiring, terminals and connector FCDIM
Visual Inspection and Diagnostic Pre-checks
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.