Yes | GO to AD10 |
|---|---|
No | GO to AD9 |
AD9 CHECK THE HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (+) AND HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (-) CIRCUITS FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C251-6 | C251-14 |
Is the resistance greater than 10,000 ohms?
Yes | REPAIR the DLC or REPAIR the circuit in question. |
|---|---|
No | A capacitor internal to a module can still be draining, causing irregular resistance readings. WAIT 5 minutes. REPEAT the pinpoint test. If the concern is still present, REPAIR the circuit. |
AD10 CHECK THE HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (+) AND HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (-) CIRCUITS FOR A SHORT TOGETHER WITH THE MODULES DISCONNECTED
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C251-6 | C251-14 |
Disconnect modules one at a time until the resistance is greater than 3 ohms.
APIM (if equipped) C2383 or C2342 (touchscreen display) BCM C2280G ICM C2114 (if equipped) PCM C1551B (2.3L), C1381B (3.7L) or C175B (5.0L, 5.2L)
Did the resistance change to greater than 3 ohms with one of the modules disconnected?
Yes | For the APIM, GO to AD21 For the BCM, GO to AD20 For the ICM, GO to AD22 For the PCM, GO to AD19 |
|---|---|
No | REPAIR the circuit in question. CONNECT all modules. |
AD11 CHECK THE HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (+) AND HS-CAN1 (HIGH SPEED-CONTROLLER AREA NETWORK 1) (-) CIRCUITS FOR A SHORT TO GROUND WITH THE MODULES DISCONNECTED
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.