AG26 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) DISABLED
NOTE: When re-running the network test, close the network test application first or the screen display reverts back to the prior network test results.
Disconnect: BJB fuse 66 (5A) to disable the SODL and SODR (if equipped). Using a diagnostic scan tool, perform the network test.
Do all other modules pass the network test?
Yes | INSTALL the removed fuse. GO to AG27 |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
AG27 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) DISCONNECTED
NOTE: When re-running the network test, close the network test application first or the screen display reverts back to the prior network test results.
Disconnect: SODR C4370 (if equipped). Using a diagnostic scan tool, perform the network test.
Do all other modules pass the network test?
Yes | CONNECT the SODR. GO to Pinpoint Test X |
|---|---|
No | CONNECT the SODR. GO to Pinpoint Test W |
AG28 CHECK THE APIM (SYNC MODULE) FOR CORRECT OPERATION
Ignition OFF. Disconnect and inspect the APIM connector and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the APIM connector and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (APIM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
AG29 CHECK THE BODY CONTROL MODULE B (BCMB) FOR CORRECT OPERATION
Ignition OFF. Disconnect and inspect the Body Control Module B (BCMB) connectors and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins)
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.