AG34 CHECK THE DSM (DRIVER FRONT SEAT MODULE) FOR CORRECT OPERATION
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the DSM connectors and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DSM. REFER to: Driver Front Seat Module (DSM) (501-10A Front Seats, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
AG35 CHECK THE MOVEABLE ROOF CONTROL MODULE A (MRCMA) FOR CORRECT OPERATION
Ignition OFF. Disconnect and inspect all Moveable Roof Control Module A (MRCMA) connector and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the Moveable Roof Control Module A (MRCMA) connector and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new Moveable Roof Control Module A (MRCMA). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
AG36 CHECK THE MOVEABLE ROOF CONTROL MODULE B (MRCMB) FOR CORRECT OPERATION
Ignition OFF. Disconnect and inspect all Moveable Roof Control Module B (MRCMB) connector and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the Moveable Roof Control Module B (MRCMB) connector and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.