E2 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
B1305:01
Refer to Wiring Diagrams Cell 117 for schematic and connector information.
Normal Operations and Fault Conditions
REFER to: Perimeter Anti-Theft Alarm - System Operation and Component Description (419-01A Perimeter Anti-Theft Alarm, Description and Operation).
BCM DTC Fault Trigger Conditions
Description | Fault Trigger Conditions |
|---|---|
B1305:01 Hood Switch: General Electrical Failure | Sets when the BCM detects an open from the hood ajar switch input during a self-test. |
DTC
Possible Causes
Wiring, terminals or connectors Hood latch BCM
Visual Inspection and Diagnostic Pre-checks
Inspect the hood latch for damage
PINPOINT TEST F : B1305:01
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
F1 CHECK THE HOOD AJAR SWITCH
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.