Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C127-2 | C127-1 |
Using a diagnostic scan tool, perform the BCM self-test.
Is DTC B1305:01 still present?
Yes | REMOVE the fused jumper wire. GO to F2 |
|---|---|
No | REMOVE the fused jumper wire. INSTALL a new hood latch. REFER to: Hood Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). |
F2 CHECK THE HOOD AJAR SWITCH GROUND CIRCUIT FOR AN OPEN
Connect:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C127-2 | Ground |
Using a diagnostic scan tool, perform the BCM self-test.
Is DTC B1305:01 still present?
Yes | REMOVE the fused jumper wire. GO to F3 |
|---|---|
No | REMOVE the fused jumper wire. REPAIR the circuit. |
F3 CHECK THE HOOD AJAR SWITCH INPUT CIRCUIT FOR AN OPEN
Ignition OFF. Disconnect BCM C2280F. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C127-2 | C2280F-14 |
Is the resistance less than 3 ohms?
Yes | GO to F4 |
|---|---|
No | REPAIR the circuit. |
F4 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.