Passive Anti-Theft System (PATS) — 2016 workshop reference 6027

D10 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION

Disconnect and inspect all of the BCM connectors. Repair:

corrosion (install new connectors or terminals, clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary

Reconnect all the BCM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM).
No	The system is operating correctly at this time. The concern may have been caused by module connections. Address the root cause of any connector or pin issues.

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical

Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM).

The system is operating correctly at this time. The concern may have been caused by module connections. Address the root cause of any connector or pin issues.

Source reference 6027

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.