Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SODR. REFER to: Side Obstacle Detection Control Module (419-04 Side and Rear Vision, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
An Exterior Mirror Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED Is Inoperative
Refer to Wiring Diagrams Cell 146 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Blind Spot Information System - System Operation and Component Description (419-04 Side and Rear Vision, Description and Operation).
DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | This DTC sets in continuous memory and on-demand in the SODL or SODR when a higher than expected current draw (such as a short to ground) is detected on the LH or RH exterior mirror Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED output circuit for 2.5 seconds. |
B11D6:15 Driver Display Alert LED: Circuit Short To Battery or Open | This DTC sets in continuous memory and on-demand in the SODL or SODR when an open circuit is detected on the LH or RH exterior mirror Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED output circuit for 2.5 seconds. |
Possible Sources
Wiring, terminals or connectors Communication network concern Exterior mirror SODL SODR Exterior mirror Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) LED (integral to the exterior mirror glass)
PINPOINT TEST D : AN EXTERIOR MIRROR BLIND SPOT INFORMATION SYSTEM (BLIS®)/CROSS
TRAFFIC ALERT (CTA) LED (LIGHT EMITTING DIODE) IS INOPERATIVE
D1 CHECK THE BLIND SPOT INFORMATION SYSTEM (BLIS®)/CROSS TRAFFIC ALERT (CTA) OPERATION
Start the engine. Observe the left and right exterior mirror Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) Light Emitting Diodes (LEDs).
Do the left and right Blind Spot Information System (BLIS®)/Cross Traffic Alert (CTA) Light Emitting Diodes (LEDs) illuminate and turn off after 3 seconds?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.