MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Electronic Feature Group

Blind Spot Information System

419-04 Side and Rear Vision

2016 MustangReference 6,172 / 6,619HTML edition
← Chapter contentsProcedure contents

Yes

The system is operating correctly at this time. The concern may have been caused by an intermittent fault condition. VERIFY the operation of the Blind Spot Information System (BLIS®) and Cross Traffic Alert (CTA) system.

No

GO to D2

D2 VERIFY THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) PASS THE NETWORK TEST

Ignition OFF. Ignition ON. Using a diagnostic scan tool, perform a network test.

Do the SODL and SODR pass the network test?

Yes

GO to D3

No

REFER to: Communications Network (418-00 Module Communications Network) .

D3 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) SELF-TESTS

Using a diagnostic scan tool, perform the SODL and SODR self-tests.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes

For DTC B11D6:11 or DTC B11D6:15, GO to D4 For all other Diagnostic Trouble Codes (DTCs), REFER to the DTC chart in this section.

No

GO to D5

D4 CHECK THE EXTERIOR MIRROR BLIND SPOT INFORMATION SYSTEM (BLIS®)/CROSS TRAFFIC ALERT (CTA) LED (LIGHT EMITTING DIODE) SUPPLY CIRCUIT FOR A SHORT TO GROUND

Ignition OFF. Disconnect: SODL C4369 (LH LED concern). Disconnect: SODR C4370 (RH LED concern). Measure:

Click to display connectors

SODL

Positive Lead

Measurement / Action

Negative Lead

C4369-4

Ground

Click to display connectors

SODR

Positive Lead

Measurement / Action

Negative Lead

Source reference 6172

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.