No | GO to F2 |
|---|
F2 PERFORM A NETWORK TEST
Ignition ON. Using a diagnostic scan tool, perform a network test.
Do the IPC, SODL and SODR pass the network test?
Yes | GO to F3 | |
|---|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . | |
F3 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) SELF-TESTS
Using a diagnostic scan tool, perform the SODL and SODR self-tests.
Are any Diagnostic Trouble Codes (DTCs) present?
Yes | REFER to the DTC chart in this section. | |
|---|---|---|
No | GO to F4 | |
F4 CHECK THE MESSAGE CENTER FOR CORRECT OPERATION
Check the message center for correct operation while turning the Blind Spot Information System (BLIS®) and Cross Traffic Alert (CTA) system on and off.
Does the message center function correctly?
Yes | The system is operating correctly at this time. The concern may have been caused by an intermittent fault condition. | |
|---|---|---|
No | REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes) . | |
DTC U0100:00
Refer to Wiring Diagrams Cell 14 for schematic and connector information.
Normal Operation and Fault Conditions
The SODL and SODR communicate with the PCM through the GWM.
DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.