The exterior mirror turn indicator is inoperative or always on | Wiring, terminals or connectors Communication concern (vehicles with memory mirrors) Turn indicator Door module (vehicles with memory mirrors) BCM | REFER to: Turn Signal and Hazard Lamps (417-01 Exterior Lighting, Diagnosis and Testing). |
The Blind Spot Information System (BLIS®) indicator is inoperative or always on | Wiring, terminals or connectors Exterior mirror glass Side obstacle detection control module | REFER to: Blind Spot Information System (419-04 Side and Rear Vision, Diagnosis and Testing). |
Symptom Chart: Rear View Mirrors - Interior
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
NOTE: Clean the entire mirror assembly and glass to assist in verification of the customer concern and/or impact damage. Do not clean any mirror glass or housing with an ice scraper, razor blade, abrasive pad, harsh chemicals or petroleum based cleaning products, as these may damage the mirror glass and/or housing.
Condition | Possible Causes | Action |
The interior mirror is blemished | Interior mirror glass/housing is dirty | CLEAN the affected interior mirror surface. |
The interior mirror vibrates or is loose | Interior mirror mounting loose | If the mirror is still on the windshield, do not remove . ATTEMPT to fully seat the mirror first. If the mirror is still loose or vibrates, REMOVE and REINSTALL the mirror. If the condition still exists, INSTALL a new interior mirror. REFER to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation). |
The interior auto-dimming mirror does not operate correctly | Refer to the Pinpoint Test | GO to Pinpoint Test H |
Symptom Chart: Rear View Mirrors - Exterior NVH
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
NOTE: Clean the entire mirror assembly and glass to assist in verification of the customer concern and/or impact damage. Do not clean any mirror glass or housing with an ice scraper, razor blade, abrasive pad, harsh chemicals or petroleum based cleaning products, as these may damage the mirror glass and/or housing.
Condition | Possible Causes | Action |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.