Yes | REPAIR the circuit in question. GO to C28 |
|---|---|
No | GO to C26 |
C26 CHECK THE HORIZONTAL MOTOR CIRCUITS FOR AN OPEN
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C341B-9 | C362-3 | |
C341B-12 | C362-1 |
Are the resistances less than 3 ohms?
Yes | GO to C27 |
|---|---|
No | REPAIR the circuit in question. GO to C28 |
C27 CHECK THE DSM (DRIVER FRONT SEAT MODULE) OPERATION
Ignition OFF. Disconnect and inspect all of the DSM connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins as necessary pushed-out pins - install new pins as necessary
Reconnect the DSM connectors. Make sure they seat and latch correctly.
NOTE: Do not reconnect Driver Side Airbag In-line C345 at this time. Reconnect all previously disconnected connectors. Ignition ON. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DSM. REFER to: Driver Front Seat Module (DSM) (501-10A Front Seats, Removal and Installation). GO to C28 |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. GO to C28 |
C28 VERIFY THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) PROVES OUT SUCCESSFULLY
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Connect: Driver Side Airbag In-line C345. Connect all previously disconnected connectors.
REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures).
Did the SRS prove out successfully?
Yes | Repair is complete. RETURN the vehicle to the customer. |
|---|---|
No | REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). |
The Memory Seat Does Not Operate Using the Memory SET Switch
Refer to Wiring Diagrams Cell 123 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Front Seats - System Operation and Component Description (501-10A Front Seats, Description and Operation).
DSM DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.