Is the blower motor correctly installed and the foam pad OK?
Yes | GO to AC6 |
|---|---|
No | Correctly INSTALL the cushion blower motor or INSTALL a new seat cushion foam pad. |
AC6 CHECK BACKREST BLOWER MOTOR THERMO ELECTRIC DEVICE CIRCUIT FOR A SHORT TO VOLTAGE
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Position the passenger seat in the vehicle and connect the seat-to-floor connectors. Disconnect: Passenger Side Airbag In-line C219. Disconnect: SCME C3265A. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265A-D | Ground |
Is any voltage present?
Yes | REPAIR the circuit. GO to AC36 |
|---|---|
No | GO to AC7 |
AC7 CHECK BACKREST BLOWER MOTOR THERMO ELECTRIC DEVICE CIRCUIT FOR A SHORT TO GROUND
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265A-C | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to AC8 |
|---|---|
No | REPAIR the circuit. GO to AC36 |
AC8 CHECK THE RESISTANCE OF THE BACKREST BLOWER MOTOR THERMO ELECTRIC DEVICE AND WIRING
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265A-C | Ground | |
C3265A-D | Ground |
Are the resistances between 0.9 and 10 ohms?
Yes | GO to AC10 |
|---|---|
No | GO to AC9 |
AC9 CHECK THE RESISTANCE OF THE BACKREST BLOWER MOTOR THERMO ELECTRIC DEVICE
Disconnect: Passenger Seat Backrest Blower Motor C3039. Measure the component side resistance between:
Positive Lead | Measurement / Action | Negative Lead |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.