Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3039-1, Component Side | C3039-2, Component Side |
Is the resistance less than 3 ohms?
Yes | REPAIR circuit CHS06 (BU/BN) or RHS06 (WH) for an open or high resistance. GO to AC36 |
|---|---|
No | INSTALL a new backrest blower motor. REFER to: Front Seat Backrest Blower Motor (501-10 Front Seats) . GO to AC36 |
AC10 CHECK BLOWER CIRCUIT AND SPEED CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
Disconnect: SCME C3265C. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265C-8 | Ground | |
C3265C-3 | Ground |
Is any voltage present?
Yes | REPAIR the circuit in question. GO to AC36 |
|---|---|
No | GO to AC11 |
AC11 CHECK BLOWER AND SPEED CONTROL CIRCUITS FOR A SHORT TO GROUND
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265C-8 | Ground | |
C3265C-3 | Ground |
Are the resistances greater than 10,000 ohms?
Yes | GO to AC12 |
|---|---|
No | REPAIR the circuit in question. GO to AC36 |
AC12 CHECK THE BLOWER AND WIRING
NOTE: The ohmmeter must be connected with the positive lead to pin 8 and the negative lead to pin 7 when measuring. Ohmmeter leads incorrectly connected will result in false readings and lead to incorrect identification of components that are not faulty. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C3265C-8 | C3265C-7 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.