Locks, Latches and Entry Systems
DTC Chart: BCM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
BCM DTC Chart
DTC | Description | Action |
|---|---|---|
B10AB:00 | Remote Keyless Entry Synchronization: No Sub Type Information | GO to Pinpoint Test O |
B10C7:01 | Interior Trunk Antenna: General Electrical Failure | GO to Pinpoint Test T |
B11C6:01 | Passenger Door External Antenna: General Electrical Failure | GO to Pinpoint Test S |
B11CA:01 | Driver Door External Antenna: General Electrical Failure | GO to Pinpoint Test S |
B1218:00 | Transmitter Identification Code: No Sub Type Information | GO to Pinpoint Test O |
B1219:11 | Interior Boot/Trunk Release Switch: Circuit Short To Ground | GO to Pinpoint Test N |
B126A:01 | Drivers Door Interior Lock Switch: General Electrical Failure | GO to Pinpoint Test J |
B1381:11 | Left Front Door Handle Proximity Sensor: Circuit Short To Ground | GO to Pinpoint Test S |
B1381:15 | Left Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | GO to Pinpoint Test S |
B1381:29 | Left Front Door Handle Proximity Sensor: Signal Invalid | GO to Pinpoint Test S |
B1382:11 | Right Front Door Handle Proximity Sensor: Circuit Short To Ground | GO to Pinpoint Test S |
B1382:15 | Right Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | GO to Pinpoint Test S |
B1382:29 | Right Front Door Handle Proximity Sensor: Signal Invalid | GO to Pinpoint Test S |
B1490:11 | Lock Indicator LED Status Output: Circuit Short To Ground | GO to Pinpoint Test L |
B1490:15 | Lock Indicator LED Status Output: Circuit Short To Battery or Open | If the door lock indicator is inoperative, GO to Pinpoint Test L If the door lock indicator is always on, GO to Pinpoint Test M |
C1017:11 | Boot/Trunk Primary Switch: Circuit Short To Ground | GO to Pinpoint Test N |
U0258:87 | Lost Communication With Radio Transceiver: Missing Message | GO to Pinpoint Test V |
All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
DTC Chart: RTM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
RTM DTC Chart
DTC | Description | Action |
|---|---|---|
U0146:00 | Lost Communication With Gateway "A": No Sub Type Information | GO to Pinpoint Test U |
U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | DIAGNOSE all non-network Diagnostic Trouble Codes (DTCs) from the PCM. Refer to the appropriate section in Group 303 for the procedure. |
U0401:82 | Invalid Data Received from ECM/PCM A: Alive / Sequence Counter Incorrect / Not Updated | DIAGNOSE all non-network Diagnostic Trouble Codes (DTCs) from the PCM. Refer to the appropriate section in Group 303 for the procedure. |
U1A00:00 Private Communication Network: No Sub Type Information | GO to Pinpoint Test V |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.