DTC | Description | Action |
|---|---|---|
U0208:00 | Lost Communication With "Seat Control Module A": No Sub Type Information | GO to Pinpoint Test X |
U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
U0300:4A Internal Control Module Software Incompatibility: Incorrect Component Installed | PERFORM the PMI using as-built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). | |
U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) from the BCM. REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
U0509:00 | Invalid Data Received From "Seat Control Module A": No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) from the DSM. REFER to: Front Seats (501-10A Front Seats, Diagnosis and Testing). |
U2002:24 | Switch: Signal Stuck High | REFER to: Glass, Frames and Mechanisms (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
U2010:00 | Switch Illumination: No Sub Type Information | REFER to: Instrument Panel and Interior Switches Illumination (413-00 Instrument Panel and Interior Switches Illumination, Diagnosis and Testing). |
U2014:00 | Control Module Hardware: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
U2100:00 | Initial Configuration Not Complete: No Sub Type Information | PERFORM the PMI using as-built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
U3000:04 | Control Module: System Internal Failure | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
DTC Chart: PCM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
PCM DTC Chart
DTC | Description | Action |
|---|---|---|
P1594 | Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout | GO to Pinpoint Test Y |
P1595 | Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position | GO to Pinpoint Test Y |
All other Diagnostic Trouble Codes (DTCs) | - | REFER to the appropriate 303-14 section. |
Symptom Charts
Symptom Chart: Handles, Locks, Latches and Entry Systems - Mechanical
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Condition | Possible Sources | Actions |
|---|---|---|
Hard to open or close a door from either door handle | Refer to the Pinpoint Test | GO to Pinpoint Test A |
A door is difficult or does not open from the exterior door handle | Refer to the Pinpoint Test | GO to Pinpoint Test B |
A door is difficult or does not open from the interior door handle | Refer to the Pinpoint Test | GO to Pinpoint Test C |
The exterior door release handle sticks | Refer to the Pinpoint Test | GO to Pinpoint Test D |
The interior door release handle sticks | Refer to the Pinpoint Test | GO to Pinpoint Test E |
Squeak-rattle-chucking noise from door | Refer to the Pinpoint Test | GO to Pinpoint Test F |
The manual door lock cylinder is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test G |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.