Yes | Click here to access Guided Routine (BCM). |
|---|---|
No | INSTALL a new DDM or PDM. REFER to: Driver Door Module (DDM) (419-10 Multifunction Electronic Modules, Removal and Installation). REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
U0208:00
Normal Operation and Fault Conditions
The DDM/ PDM communicate with the DSM over the CAN. If the DDM/ PDM does not receive messages from the DSM, features such as the memory mirror position can be inoperative.
DDM/ PDM DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
U0208:00 Lost Communication With "Seat Control Module A": No Sub-Type Information | Sets when the DDM/ PDM detects data messages are missing from the DSM. |
Possible Cause
Network communication concern DDM/ PDM DSM
PINPOINT TEST X : U0208:00
X1 VERIFY THE CUSTOMER CONCERN
Ignition ON. Verify there is an observable symptom present.
Is an observable symptom present?
Yes | GO to X2 |
|---|---|
No | The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
X2 CHECK THE COMMUNICATION NETWORK
Using a diagnostic scan tool, perform a network test.
Does the DSM pass the network test?
Yes | GO to X3 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing). |
X3 CHECK FOR DSM (DRIVER FRONT SEAT MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the DSM self-test.
Are any voltage related Diagnostic Trouble Codes (DTCs) present?
Yes | REFER to: Front Seats (501-10A Front Seats, Diagnosis and Testing). |
|---|---|
No | GO to X4 |
X4 RECHECK THE DDM (DRIVER DOOR MODULE) OR PDM (PASSENGER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during PMI or the PMI may not have been performed. Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) and repeat the DDM/ PDM self-test.
Is DTC U0208:00 still present?
Yes | GO to X5 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.