X5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0208 SET IN OTHER MODULES
Is DTC U0208 set in other modules?
Yes | INSTALL a new DSM. REFER to: Driver Front Seat Module (DSM) (501-10A Front Seats, Removal and Installation). |
|---|---|
No | INSTALL a new DDM or PDM. REFER to: Driver Door Module (DDM) (419-10 Multifunction Electronic Modules, Removal and Installation). REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
P1594 OR P1595
Normal Operation and Fault Conditions
When the BCM receives a request to remote start the vehicle, it first checks to make sure conditions exist to allow it to start (for example, the hood and doors closed, vehicle in PARK, no powertrain concerns). If the required conditions are correct, the BCM starts the vehicle and allows it to run for a predetermined amount of time, determined by the setting selected from the message center.
PCM DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
P1594 Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout | Sets when the PCM detects the remote start has been active for more than 30 minutes continuously. | |
P1595 Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position | Sets when the PCM detects the remote start is active with the transmission not in PARK. |
Possible Cause
Network communication concern Powertrain concern BCM
PINPOINT TEST Y : P1594 OR P1595
Y1 CHECK FOR OTHER PCM (POWERTRAIN CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Review the results from the PCM self-test.
Are any other PCM Diagnostic Trouble Codes (DTCs) present?
Yes | DIAGNOSE all other PCM Diagnostic Trouble Codes (DTCs) first. Refer to the appropriate section in Group 303 for the procedure. |
|---|---|
No | GO to Y2 |
Y2 CHECK FOR BCM (BODY CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Ignition ON. Using a diagnostic scan tool, perform the BCM self-test.
Are any BCM Diagnostic Trouble Codes (DTCs) present?
Yes | REFER to the BCM DTC Chart in this section. |
|---|---|
No | GO to Y3 |
Y3 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all the BCM connectors. Repair:
corrosion (install new connectors or terminals - clean module pins) damaged or bent pins - install new terminals pins pushed-out pins - install new pins as necessary
Reconnect the BCM connectors and make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.