Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
Wiper relay, cavity 2 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to D10 |
|---|---|
No | REPAIR the circuit. |
D7 CHECK THE WINDSHIELD WIPER MOTOR VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE
Disconnect Wiper Relay. Observe the windshield wiper operation.
Does the windshield wiper motor continue to operate?
Yes | REPAIR the circuit. |
|---|---|
No | INSTALL a new wiper relay. |
D8 CHECK FOR CORRECT WINDSHIELD WIPER MOTOR OPERATION
Disconnect and inspect the windshield wiper motor connector. Repair:
corrosion (install new connector or terminal - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the windshield wiper motor connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new windshield wiper motor. REFER to: Windshield Wiper Motor - LHD (501-16 Wipers and Washers, Removal and Installation). |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.