No | INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). TEST the system for normal operation. If the concern is still present, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). |
|---|
The Rain Sensitive Wiper Feature Is Inoperative Or Does Not Operate Correctly
Refer to Wiring Diagrams Cell 81 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description (501-16 Wipers and Washers, Description and Operation).
SCCM DTC Fault Trigger Conditions
Description | Fault Trigger Conditions |
|---|---|
B10AD:02 Rain Sensor: General Signal Failure | Sets when the SCCM detects a communication fault with the rain sensor. |
B10AD:08 Rain Sensor: Bus Signal / Message Failure | Sets when the SCCM detects a communication fault with the rain sensor. |
DTC
Possible Causes
Fuse Wiring, terminals or connectors Rain sensitive feature not enabled Foreign material on windshield, such as dirt, dust or bugs Wiper blades Windshield glass Wiper/washer switch Windshield wiper motor Rain sensor SCCM
Visual Inspection and Diagnostic Pre-checks
Inspect the windshield for damage Inspect the rain sensor mounting for damage Inspect BJB fuse 72 (5A)
PINPOINT TEST F : THE RAIN SENSITIVE WIPER FEATURE IS INOPERATIVE OR DOES NOT
OPERATE CORRECTLY
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
F1 CHECK THE LOW SPEED WIPER OPERATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.